La Crosse Technology Kcombo5 - Manual (Page 9)

9
HOW TO INSTALL AND REPLACE BATTERIES IN THE
TEMPERATURE TRANSMITTER
The Temperature transmitter uses 2 x AAA, IEC
LR3, 1.5V batteries. When batteries will need to be
replaced, the low battery icon will appear on the
LCD of the Temperature Station. To install and
replace the batteries, please follow the steps
below:
1.
Remove the battery compartment cover.
2. Insert the batteries, observing the correct
polarity (see marking).
3. Replace the battery holder to the unit.
Note:
In the event of changing batteries in any of the units, all units need to be
reset by following the setup procedures. This is because a random
10
security code is assigned by the transmitter at start-up and this code must
be received and stored by the Temperature Station in the first few minutes
of power supplying.
BATTERY CHANGE:
It is recommended to replace the batteries in all units regularly to ensure
optimum accuracy of these units. (Battery life –see Specifications)
Please participate in the preservation of the environment.
Return used batteries to an authorized depot.
FUNCTION KEYS:
The Temperature Station has only two easy to use function keys:
11
SET key
x Press and hold for about 3 seconds to enter the Manual setting
mode.
+ key
x Press to make adjustment in the setting mode.
x Press and hold to reset all MIN/MAX records
+ key
SET key
12
Outdoor Reception
Signal icon*
MIN/MAX Outdoor
temperature
LCD SCREEN AND SETTINGS:
Time
Indoor Temperature
in °F
Outdoor Temperature
in °F
MIN/MAX Indoor
temperature
Low battery indicator
(temperature station)
Low battery indicator
(transmitter)