La Crosse Technology K84285 - Manual (Page 8)

8
Alarm Set
Hold the ALARM button for 5 seconds to enter the alarm time set mode.
1. The alarm hour digit will flash.
2. Press and release the +/TEMP or -/TIME buttons to select the hour.
3. Press and release the SET button to set the minutes. The minute digits
will flash.
4. Press and release the +/TEMP or -/TIME buttons to select the minutes.
5. Press and release ALARM to confirm the alarm settings, then press and release SET button to exit.
6. The alarm icon will show after the minutes indicating the alarm is active.
7. The alarm icon will flash when the alarm is sounding.
Deactivate Alarm
1. Press and release the ALARM button once to show Alarm Time.
2. Press and release the ALARM button to deactivate the Alarm. The alarm icon will disappear
indicating the alarm is no longer active.
Snooze
1. When the alarm sounds, press the SNOOZE/LIGHT button to trigger snooze alarm for 10 minutes.
The snooze icon Zz will flash when the snooze feature is active.
2. To stop alarm for one day, press ALARM button, while in snooze mode. The alarm icon will remain
solid.
Note: When the alarm sounds, it continues for 2 minutes and then shuts off completely.
Backlight and Projection Intensity
Hold two seconds, and then release the SNOOZE/LIGHT button to adjust the brightness of the backlight
and projection (together):
• ON High intensity: (default setting on A/C power)
• ON Low intensity: Hold and release SNOOZE/LIGHT button once
• OFF: Hold and release SNOOZE/LIGHT button
• ON High intensity (default): Hold and release SNOOZE/LIGHT button
Projection
• Battery Power: Press and release the SNOOZE/LIGHT button to show the projection for 10 seconds.
• Note: Projection will not display constantly when operating on battery power.
• A/C Power: Projection is displayed constantly
• Note: can be turned off see “Backlight and Projection Intensity”
• Rotate Projection: Press and release the PROJECT button to rotate projection image 90 degrees on
the wall or ceiling. Press and release the PROJECT button again to rotate another 90 degrees.
• Change Projection Mode: Hold two seconds, and then release the PROJECT button to switch
projection modes. You will need to watch the projection image to view the changes.
o
Time and Outdoor Temperature: alternate every 5 seconds (default)
o Time: Hold and release PROJECT button
o Outdoor Temperature: Hold and release PROJECT button again
Note: Both time and outdoor temperature will not show at the same time.