La Crosse Technology BC-1000U - Manual (Page 20)

19
NOTE:
 Press the MODE key within 8 seconds after inserting the rechargeable batteries; the
Refresh mode can be selected. (Hold the MODE key for about 1 second to activate the
mode change. Press and release the MODE key to select the ―Charge‖, ―Discharge‖,
―Test‖ and ―Refresh‖ mode.)
Select different discharging cur
rent by pressing the CURRENT key (see ―Note‖ in
Discharge mode and Table 2), within 8 seconds after inserting the batteries. (Or the
display will blink once to indicate the end of setting and the current cannot be changed
afterward.).
 It may take up to several days to finish the refreshing process, depending on the selected
discharging current.
 The maximum refresh current is 1000 mA and is not affected by the number of
rechargeable batteries inserted.
TEST MODE
In the Test mode the rechargeable batteries will first be fully charged and then discharged to
determine the capacities. Finally, the rechargeable batteries are charged up again and the
capacity in (mAh) or (Ah) will alternate every 3 seconds with the FULL sign.