Kussmaul Electronics 091-185-009 - Manual (Page 2)

E-Z MOUNTING PLATE INSTRUCTIONS
TRUCK WALL
SUPER AUTO EJECT
E-Z MOUNTING PLATE
GASKET
E-Z MOUNTING PLATE
INDICATOR
“O” RING
COVER
COVER GASKET
#8 x ½” THREAD CUTTING
SCREW
#8 x 1”
SS SCREW
HEX NUT
1. Locate a convenient place on the vehicle to mount the AUTO EJECT. A minimum clearance of 3
inches behind the mounting panel is required.
2. Place the Hole Template (Figure 2) in position and center punch in 4 places.
3. Drill 4 mounting holes, #29 drill (0.136” diameter). Be certain that all the holes are precisely located.
4. Cutout rectangular hole.
5. See Figure 1, Mounting. Install Weatherproof Cover, Weatherproof Cover Gasket,Indicator light to
E-Z Mounting Plate, and install to Super Auto Eject using (4)#8-32 x 1” screws provided.
6. Install that assembly and E-Z mount gasket into cutout in truck wall using (4)#8-32 x ½” self tapping
screws provided.
7. Use the Auto Eject instruction manual for wiring information. Wire the indicator to any 120 VAC circuit
on the vehicle so when the Auto Eject is plugged in the indicator will illuminate.
Figure1 Mounting