Installation – Kussmaul Electronics 091-145HO-12 User Manual
Page 3
3
INSTALLATION
The Auto Charge Dual 12 Volt-20 amp Automatic Battery Charger should be installed in an
area with adequate ventilation. Wiring is illustrated in figure 1 and figure 2.
1. Mount the charger using the four holes provided for this.
2. Connect the wiring from the batteries to the Output Terminal Strip.
3. Double- check all wiring before proceeding.
4. Connect the A.C. power through the provided line cord (attached to the charger).
5. Pilot light will show that the charger has power.
Figure 2 illustrates this charger connected to two batteries in series. Each battery is
individually charged and charging ceases automatically when that battery is fully charged.
Thus if battery 1 requires more charging due to the accessory load, charging to battery 1 will
continue even after the charger has stopped charging battery 2. This ensures that both
batteries will be fully charged but neither will be over-charged.
- 091-7-12 (5 pages)
- 091-12HO-PIM (5 pages)
- 091-12PIM (5 pages)
- 091-12VHO-24 (5 pages)
- 091-31-12 (4 pages)
- 091-170-12 (9 pages)
- 091-90-12 (6 pages)
- 091-162-12 (5 pages)
- 091-165-24 (11 pages)
- 091-165-24-DV (6 pages)
- 091-168-12 (8 pages)
- 091-170-DV (6 pages)
- 091-193-12 (10 pages)
- 091-200-12 (10 pages)
- 091-195-12 (8 pages)
- 091-195-12-USB (7 pages)
- 091-136-24-12 (3 pages)
- 091-18WP-012 (6 pages)
- 091-55-20-120 (5 pages)
- 091-182-230-12 (5 pages)
- 091-159-30-250-24 (11 pages)
- 091-159-430-250-24 (9 pages)
- 091-9 (8 pages)
- 091-9-12V-AD (4 pages)
- 091-9 (8 pages)
- 091-9 (9 pages)
- 091-9B-1-AD (5 pages)
- 091-9HP (6 pages)
- 091-9HP-AD (5 pages)
- 091-9H-1 (1 page)
- 091-150 (5 pages)
- 091-150-115 (7 pages)
- 091-205 (4 pages)
- 091-160 (2 pages)
- 091-174 (4 pages)
- 091-32-024 (1 page)
- 091-139-2-12 (7 pages)
- 091-32-029 (1 page)
- 091-36 (5 pages)
- 091-98-12 (1 page)
- 091-45 (7 pages)
- 091-100-012 (1 page)
- 091-103-012 (1 page)
- 091-108-012 (5 pages)
- 091-134A (4 pages)