Kussmaul Electronics 091-182-230-12 - Manual (Page 3)

INSTALLATION INSTRUCTIONS
1. Locate a convenient place on the vehicle to mount the AUTO EJECT. A minimum clearance of
4 5/8"(115mm) behind the mounting panel is required.
2. Place the Hole Template in position and center punch and drill in 6 places.
3. Mount the Auto Eject as shown in Figure 2.
4. Connect the DC wiring. Install the DC cable, use the 2 white connectors as shown in Figure 3.
USE #16 GAUGE WIRE OR HEAVIER.
5. Connect the AC wiring. Prepare the AC cable as shown in Figure 1. Then install the AC cable
as shown in Figure 3. USE #14 GAUGE WIRE OR HEAVIER.
6. Test installation by installing mating connector into the AUTO EJECT. Energizing the starter
should energize the solenoid and eject the connector.
7. Keep connector and contacts of the AUTO EJECT clean . Lubricate contacts bi-annually with
graphite petrolatum to insure free operation.
Note: USE ONLY CORD CONNECTOR (PLUG) SUPPLIED WITH THE AUTO EJECT
All connectors are not identical, using a substitute may result in unreliable
operations or failure of the AUTO EJECT to operate.
SUPER AUTO EJECT
Truck Wall
Gasket
Magnet captive in cover
when cover is installed
Weather
Proof Cover
#M4 x 16mm
Pan Head
Screw
Chassis
Ground
Solenoid
Vehicle Starter
To Battery
AC Incoming
Power to Vehicle
Red
Black
FIGURE 2 Mounting