Wiring – Kussmaul Electronics 091-170-12 User Manual
Page 4
IV. LED STATUS INDICATOR
1. POWER: Indicates that AC voltage is present
WIRING
I. BATTERY CHARGER WIRING INSTRUCTIONS
1. Refer to Installation Wiring Diagram.
2. Refer to Wiring Specifications to determine the recommended wire size and maximum lengths.
Using a smaller gauge may cause overheating of the terminal. Additional information is available
upon request if longer, larger wiring is required.
3. Double check all wiring before applying AC power volts to input terminal.
4. Apply AC power (shoreline power) to input terminal and observe that the charger is operating.
5. Verify that the battery voltage appears at the charger output terminals.
II. WIRING SPECIFICATIONS
1. For Model #: 091-170-6
Length of Wire to Battery (feet)
0 - 5
< 5 - 10**
< 10 - 20*
Battery Charger Connections
BAT +
COM
BAT +
COM
BAT +
COM
12
12
10
10
8
8
* Consult factory if length of wire to battery is longer than 20 feet
2. For Model #: 091-170-12
Length of Wire to Battery (feet)
0 - 5
< 5 - 10**
< 10 - 20*
Battery Charger Connections
BAT +
COM
BAT +
COM
BAT +
COM
12
12
10
10
8
8
* Consult factory if length of wire to battery is longer than 20 feet
3. For Model #: 091-170-24
Length of Wire to Battery (feet)
0 - 5
< 5 - 10**
< 10 - 20*
Battery Charger Connections
BAT +
COM
BAT +
COM
BAT +
COM
14
14
12
12
10
10
* Consult factory if length of wire to battery is longer than 20 feet
170 Cherry Avenue
West Sayville, NY 11796
www.kussmaul.com
Ph: 800-346-0857
Fax: 631-567-5826
4