Kussmaul Electronics 091-165-12 - Manual (Page 2)

2
IMPORTANT SAFETY INSTRUCTIONS
1. SAVE THESE INSTRUCTIONS – This manual contains important safety and operating
instructions for battery charger Model 091-165-12.
2. Do not expose charger to rain or snow.
3. Use of an attachment not recommended or sold by the battery charger manufacturer
may result in a risk of fire, electric shock, or injury to persons.
4. Wire Battery Charger; 115VAC, 50/60Hz Input Power per Figure 1 of this manual in
accordance with ALL; National, Local and/or Underwriter requirements for a NEMA,
115VAC, 15 Ampere appliance.
5. Portable extension cords on 115VAC Input or 12VDC Output should not be used unless
absolutely necessary. Use of improper extension cord could result in a risk of fire and
electric shock. If extension cord must be used;
a) 115VAC input power cord shall comply with UL 1236 Edition 7, Table 11.1
"Acceptable Flexible Cords for Battery Chargers".
b) That extension cord is properly wired and in good electrical condition.
c) That wire size is large enough for ampere rating of charger as specified in Table
52.1 of UL 1236 Edition 7, "Recommended Minimum AWG Size for Extension
Cords for Battery Chargers".
6. Do not operate charger with damaged cord or plug – replace the cord or plug
immediately.
7. Do not operate charger if it has received a sharp blow, been dropped, or otherwise
damaged in any way; take it to a qualified serviceman.
8. Do not disassemble charger; take it to a qualified serviceman when service or repair
is required. Incorrect reassembly may result in a risk of electric shock or fire.
9. To reduce risk of electric shock, unplug charger from outlet before attempting any
maintenance or cleaning.