Kiddy World plus - Manual (Page 14)

• Slide locking clip onto vehicle seat belts
approximately 1/2 inch (1 cm) away from latch plate
(Fig. 8).
• Re-buckle vehicle seat belt.
- Check to be sure vehicle lap belt is still correctly
routed throughout entire belt path.
- Check to see that the protection shield is snuggly
adjusted onto child.
- If not snuggly adjusted, readjusting the vehicle seat
belt tightening is required.
- Unbuckle vehicle seat belt.
- Hold vehicle seat belts together and remove locking
clip.
- Readjust the lap belt.
- Re-attach locking clip.
- Buckle vehicle seat belt.
- Test installation to see if protection shield is snuggly
adjusted, if not snugly adjusted, repeat above steps
until protection shield is snugly adjusted.
• Check that the protection shield is snuggly adjusted
onto the child’s torso each time the child is secured
into the Todder car Seat.
4.4 Vehicle seat back and headrest adjustment
- Place the car seat on the vehicle seat,
center the car seat in the seating position
so that car seat back contacts the vehicle
seat back.
- The backrest of your car seat should sit
right up against the vehicle’s seat back.
- If the vehicle headrest holds the car seat
forward of the vehicle seat back, the
headrest should be removed (car seat
forward of vehicle seat back) (Fig. 9).
13
Fig. 8
Fig. 9