Kleenmaid KED420 - Manual (Page 2)

J
B
J
2
F G
1
B
A
E C D
J
3
B H
E C D J
– This tumble dryer is intended for NORMAL DOMESTIC
USE ONLY.
– Please note it is not recommended that the dryer be
placed directly next to ovens or cookers, as the
performance of the dryer may be affected.
– Any electrical work required to install the appliance
should be carried out by a qualified person.
– It is important to clean the lint filter after each drying cycle
and the condenser every three or four months or the
restrictions to airflow will extend drying times and could
cause the safety cut-out to trip.
– Do not stack the tumble dryer on top of any other
appliances without the correct stacking kit.
– Under no circumstances should anything other than the
recommended articles be placed in the tumble dryer.
– The tumble dryer should be serviced by an appointed
service organisation and only genuine parts used.
– It is dangerous to alter or modify the product in any way
other than fitting authorised accessories.
– We recommend that the appliance is unplugged each
time after use. It should always be disconnected from the
electricity supply if it is to be left unattended for long
periods (i.e. weekends, holidays etc.)
– The rear of the dryer gets quite hot during use. Position
the dryer so that the back is not accessible while in
operation, but the sides have a space available to allow
air flow.
– It is important to clean fluff from the window of the dryer
and around the door seal after each drying cycle. Failure
to do so could result in water leaking.
– DO NOT use a two-way adaptor, or extension lead. The
dryer must be connected to its own socket.
– DO NOT block the air inlets at the front and back of your
dryer.
– DO NOT allow fluff to accumulate around the tumble
dryer.
– DO NOT exceed the recommended maximum load.
– DO NOT allow children to tamper with the controls and
keep them away from the dryer when it is in operation.
– DO NOT place articles in the dryer if anything other than
a water solution has been used in the cleaning process.
– DO NOT attempt to dry dripping wet articles or items
containing foam rubber or rubber-like materials.
– DO NOT use the tumble dryer if you suspect that it is
damaged in any way. Under no circumstances should you
attempt to repair the appliance yourself. Repairs carried
out by inexperienced persons may cause serious injury.
Consult your local appointed service engineer and insist
on genuine spare parts.
THIS APPLIANCE MUST BE
EARTHED
IMPORTANT USER INFORMATION
These notes are provided in the interest of safety.
You must read them before installing or using the appliance.
REVERSING THE DOOR OPENING
MII CONDENSER FPL ‘98 4213 094 87801
Dry ers fitted with hing e cover:- Dry ers fitted without hing e cover:-
Y our dr yer is supplied with a re versib le door.T o change the direction of opening proceed as follo ws for y our type of door.
Open the door. Undo screw
(A) remove switch str ike (B)
and replace screw . Undo
screw (J) and remo ve buff er.
Remove scre ws (C) and latch
plate (D).Remo ve hinge cove r
screw (E). Close the door.
Pull the hinge cov er (F)
forw ards to remov e it.
Remov e tw o outer screws
(G). Remove door. Fit latch
plate (D) with screws (C).
Reve rse door and fit to dry er
in closed position. Refit
screws (G) and hinge co ve r
(F).Open the door .
Fit screw (E) to secure hinge
cove r. Remove screw (H) at
top of door and refit switch
strik e (B) as shown. Refit
buff er (J).
Open the door. Undo screw (A)
remove switch str ike (B) and replace
screw . Undo screw (J) and remo ve
buff er. Remove screws (C) and latch
plate (D).Remo ve hinge bloc k screws
(E).Remo ve door from hinge bloc ks.
Remov e hinge scre ws
(F) and hinge (G) and
refit to opposite side as
shown.
Refit latch plate (D) with screws (C). Remove screw (H) at top of
door and refit switch str ike (B) as sho wn.Refit b uffer (J). Fit door
to hinge bloc ks and secure with screws (E).
INSTRUCTIONS FOR USE
IMPORT ANT:
PLEASE READ THESE INSTR UCTIONS THOR OUGHL Y BEFORE USING THIS APPLIANCE.
KEEP THEM IN A SAFE PLA CE FOR FUTURE REFERENCE. GB
THE CONDENSER
The condenser and ducting should be cleaned 3 or 4 times a year
or more frequently if the dryer is in constant use. See “CLEANING
THE CONDENSER” opposite.
NOTE: The condenser will discolour through use.
REMOVING THE CONDENSER
– Firmly pull the condenser out.
RE-INSTALLING THE CONDENSER
– Carefully push the condenser back into the machine, until it is
pushed fully home and a “click” is heard.
– Ensure all lint and fluff is removed from around the grille seal
before closing or water may leak.
– IMPORTANT: The dryer may leak if the condenser is not
correctly re-installed.
CLEANING THE CONDENSER
CAUTION: For maximum efficiency, the plates are made from
very thin aluminium and are easily damaged. Do not try to poke
anything between the plates or use a hard object or tool for
cleaning. At all times, handle the condenser carefully and avoid
crushing the plates.
– Remove the condenser (see opposite).
– Flush the fluff from between the plates under running water
and carefully shake off excess water.
– Whilst the condenser is
removed, clean as much fluff
as possible from inside the
ducting by reaching a hand
into the machine. In particular,
keep the passage from the fan
clear (on the right hand side of
the condenser duct).
– After cleaning, re-install the condenser (see opposite).
10815 87801 A3 12pp Brdsht 7/2/03 11:51 AM Page 4