Kleenmaid LEG37A - Manual (Page 6)

4 510955
Before You Start . . .
Tools
For most installations, the basic tools you will need are:
Exhaust
Use rigid metal duct and exhaust the dryer to the
outside by the shortest route possible.
NOTE: For more detailed information, refer to
Section on Dryer Exhaust Requirements.
Electrical
• ELECTRIC DRYER
Dryer needs a 2 wire plus earth, 250 Volt, 50 Hertz,
20 Amp, single phase electrical supply.
• GAS DRYER
Dryer needs a 2 wire plus earth,250 Volt, 50 Hertz,
10 Amp, single phase electrical supply.
NOTE: For more detailed information, refer to
Section on Electrical Requirements.
Gas
Dryer is equipped for Natural Gas with a 3/8" NPT gas
supply connection. For more detailed information,
refer to Section on Gas Requirements.
Location
Place the dryer on a solid floor with an adequate air
supply. For more detailed information, refer to Section
on Location Requirements.
D074IE1F
DUCT TAPE TEFLON TAPE
WRENCH
LEVEL
SCREWDRIVERS
D314IE0A