Kleenmaid LTKA6 User Manual

Page 24

Washer Operation

802726

To change the cycle after the first wash is complete:

NOTE: This should only be done if the speed of the
final extract is incorrect for the fabric being
washed. For example, if washing delicate items on
the REGULAR cycle, the high speed extract may
damage the fabric. If washing towels or jeans on
the DELICATE cycle, the lower speed extract
would increase drying time.

1. Abort the current cycle by changing the cycle

selector switch to the OFF position.

2. Restart the cycle from the beginning. Refer to the

To Wash Clothes section.

To Pump Out Water After Aborting Cycle

Run a SPIN ONLY cycle. This cycle will perform a
high speed extract operation that will pump all of the
water out of the washer.

DOOR Light

When the washer is started, the DOOR light will come
on after a short delay. The light will turn off
approximately 45 seconds after the cycle is complete.

WASH Light

This light comes on during the wash part of each
cycle.

RINSE Light

This light comes on for the rinse portion of each cycle.

FINAL SPIN Light

This light comes on while the wash load is in the final
spin of the cycle.

HEATER Light (Red Light)

This light comes on during the BOOSTED HOT
setting only. While the washer is heating, the HEATER
light will turn on.

Out of Balance Load

If at the end of the cycle, the load is dripping wet, the
washer has limited the spin speed. This is to prevent
damage to the unit if there is a severely unbalanced
load.

If this condition occurs, redistribute the load manually
and run a RINSE & SPIN cycle.

If the condition persists, consider steps discussed in
the section Loading the Washer.

This manual is related to the following products:

LTKA6A N4350