Kleenmaid KFL1600 - Manual (Page 28)

130715
If the washing machine identifi es failures in the operation, it reports it
immediately. Sound alarm is heard and the display reads ERROR. Number
identifi es the type of failure.
In some cases you can attempt removing certain failures yourself (see the chart
below). The machine will continue to perform the operation after pressing the
START knob (F). The machine signals failures immediately after detecting them
and stops the program, except for heater failure, where the machine completes
the washing program without heating water (ERROR 1).
In certain cases the failures can be repairedby yourself; in all other
cases turn the machine off and call your nearest authorisedservice
centre on 1300 652 100.
ERROR 3 - check inlet hose is turned on
- check inlet hose is not kinked
- check inlet hose screen is not blocked
ERROR 7 - check the outlet hose is not blocked
- check the outlet hose is not kinked
- check the outlet hose is higher than 1m
Interferences from the ambient (for example electrical wiring) could induce
signalization of different faults. In such cases:
- switch the appliance off, and wait for a few seconds;
- switch the appliance back on and repeat the washing program.
If the fault repeats, call authorized service shop.
Warranty shall not apply in case of failures due to interferences from the
environment (lightning stroke, power supply circuit faults, natural disasters).
28
Failures