Kleenmaid K70 - Manual (Page 7)

Instructions for the installer
• Remove the grease filter(s).
• When installed, the lower side of the hood should be at least 650mm above either gas,
electric or mixed hobs or 750mm if installing above any of the following splashbacks. SK70
SK90 SK100 SK120.
1. Drill six holes (Ø 8 mm), insert 6 dowels and tighten only the 2 central hook dowels at the top.
2. Hang the hood onto the 2 upper hooks.
3. Fasten the hood to the wall definitively using the 4 remaining dowels, previously inserted into
the wall, with 4 screws (compulsory).
4. Connect a venting pipe (150 mm) to the connection ring above the suction motor unit.
PLEASE NOTE: Venting pipe and clamps are not supplied with hood.
• When using the suction version of the hood, the other end of the venting pipe must be
connected to a device that extracts fumes to the outside.
• Connect the electrics.
• Rest the lower section of the stack onto the top of the hood that covers the suction motor
compartment and fit it into its housing.
• Insert the upper section of the stack into the lower section and check that the sides with the
holes face upwards.
5. Fasten the upper bracket close to the ceiling (use the bracket as a drilling plan), pencil in two
holes, drill the holes (Ø 8 mm) and insert 2 wall dowels. Fasten the upper bracket with 2
screws 5x45 mm.
6. Fasten the upper section of the stack to the bracket with 2 screws (one on each side).
• Refit the grease filter(s) and check the hood is in good working order.