Warnings, Warnings for safety and use – Kleenmaid K70 User Manual
Page 4
Warnings
1. Warnings for safety and use
THE PRESENT MANUAL IS INTEGRAL WITH THE APPLIANCE AND MUST HENCE BE PROPERLY MAINTAINED
INTACT AND ALWAYS KEPT WITHIN EASY REACH THROUGHOUT APPLIANCE WORK LIFE. BEFORE USING THE
SUCTION APPLIANCE, WE RECOMMEND READING THIS MANUAL AND ALL THE INDICATIONS IT CONTAINS
THOROUGHLY. INSTALLATION IS TO BE CARRIED OUT SOLELY BY QUALIFIED PERSONS ACCORDING TO
PREVAILING STANDARDS. APPLIANCES HEREUNDER ARE INTENDED SOLELY FOR DOMESTIC USE AND ARE
BUILT IN COMPLIANCE WITH PREVAILING E.E.C. AND E.U. DIRECTIVES. THE MANUFACTURER SHALL NOT BE
HELD RESPONSIBLE FOR ANY ACCIDENT THAT MAY BE CAUSED BECAUSE OF IMPROPER USE.
DO NOT LEAVE ANY PIECES OF THE PACKAGING UNATTENDED IN THE HOME. SEPARATE THE VARIOUS
PACKAGING MATERIALS AND DELIVER THEM TO THE NEAREST RECYCLING CENTRE.
THE EARTH CONNECTION IS MANDATORY AND MUST CONFORM TO THE CURRENT AUSTRALIAN STANDARDS
OF THE ELECTRICAL WIRING SYSTEM.
THE PLUG TO BE CONNECTED TO THE POWER SUPPLY CABLE AND THE RELATIVE SOCKET MUST BE THE
SAME TYPE AND MUST COMPLY WITH CURRENT STANDARDS. AFTER INSTALLING THE APPLIANCE MAKE SURE
THAT THE PLUG IS ACCESSIBLE TO ALLOW THE PERIODICAL CHECK-UP.
DO NOT PULL OUT THE PLUG BY PULLING THE CABLE.
IMMEDIATELY AFTER INSTALLATION, TEST THE APPLIANCE BRIEFLY BY FOLLOWING THE INSTRUCTIONS
SHOWN BELOW. IN THE EVENT OF A MALFUNCTION, DISCONNECT THE APPLIANCE FROM THE MAINS AND
CONTACT YOUR NEAREST TECHNICAL SERVICE CENTRE.
DO NOT ATTEMPT TO REPAIR THE APPLIANCE.
THE IDENTIFICATION PLATE, WITH THE TECHNICAL DATA, SERIAL NUMBER AND MARKING, CAN BE FOUND
INSIDE THE APPLIANCE.
THE PLATE MUST NEVER BE REMOVED.
THE APPLIANCE IS INTENDED FOR USE SOLELY BY ADULTS. NEVER ALLOW CHILDREN TO COME NEAR THE
APPLIANCE OR TO PLAY WITH THEM. BE CAREFUL NOT TO LEAVE OBJECTS ON THE APPLIANCE THAT MAY
ATTRACT CHILDREN’S ATTENTION. ALWAYS KEEP CHILDREN AT A SAFE DISTANCE FROM THE APPLIANCE. THE
APPLIANCE IS NOT INTENDED FOR USE BY YOUNG CHILDREN OR INFIRM PERSONS WITHOUT SUPERVISION.
DISCARDED APPLIANCES MUST BE DELIVERED SOLELY TO A SPECIALISED WASTE COLLECTION CENTRE.
The manufacturer shall not be held responsible for any injury or damage that may be caused
by failure to fully comply with the aforementioned instructions and recommendations or by
tampering with the appliance components or the use of non-original spares.