Maintenance – Kleenmaid RHSGALA User Manual

Page 8

Warning!
The active carbon filter saturation
function is not activated.
In order to activate the carbon filter
saturation indicator, press buttons
and

simultaneously for 3 seconds.

Initially,

the

letter

will

be displayed,

then after the 3 seconds have passed,
letter

will be displayed as well,

indicating that the carbon filter
saturation control system is active.
To switch off the system, re-press the
same two buttons

. The

letter

C will

appear on the

display

fter

approx

3 seconds it will

disappear and

the device will be

switched off.

= Decrease fan speed button for

reducing speed of motor from 3 down
to speed 1.

= Increase fan speed button for

increasing speed of motor from 1 to 3.

If the

range

hood fails to operate correctly,

briefly

disconnect it from the mains power supply

for approx.

5 sec. by pulling out the plug. Then plug

in again and try once more before contacting the

Technical Assistance Service.

Always press the fan off button

before

disconnecting the

range

hood from the

mains

supply.

Warning!

— Th

appliance

is designed to be operated by

adults. Children should not be allowed to
tamper with the controls or play with the

— The

range

hood cannot be connected to

flues of

other appliances that run on energy

sources

other than electricity.

— When the

range

hood is used at the same

time as

other appliances that run on energy

sources

other than electricity, provision must

be made

for an adequate supply of air.

— No food must be cooked flambé underneath

the

range

hood.

The use of an unprotected

flame is

dangerous

for the filters and could cause

a fire. Therefore, never use an open flame

never leave the pan unattended because the
cooking oil could flare up.

— Please, keep to the provisions of official

directives regarding the question of fume
discharge.

— The manufacturers refuse to accept any

responsibility for damage to the

range

hood

or its

catching on fire because of failure to

observe

the above instructions.

Maintenance

Before performing any maintenance operation,
isolate the

range

hood from the electrical

supply by

switching off at the connector and

removing the

connector fuse.

Or if the appliance has been connected through
a plug and socket, then the plug must be removed
from the socket.

Grease Filter (1 of 2 pieces)

It’s function is to retain the grease particles
The grease filter has an unlimited life span and

can

be washed by hand or in the dishwasher

(65°) with suitable detergents.
When washed in the dishwasher the grease filter
may discolour but the filtration characteristics will
not be effected.
The grease filter must be washed at least once
a month or each time the letter

or alternatively

the selected velocity appears To disassemble
the grease filter use the appropriate handles

. F

irst

pull the handle back (a) and then down (b) Fig.
7.
Leave to dry without damaging the grease filter
before re-assembling.
After

ash

ing

the grease filter reverse

the steps used to disassemble the grease filter in
order to reassemble.
Once the grease filters have been set in place
press button

and

simultaneously for about

three seconds until the letter F shown on display
disappears.

Carbon Filter

The carbon filter extracts odours

emitted when

cooking into the flue.

It must be mounted on the inside of the

range

hood.

Under normal use the carbon filter must be washed
every two months, or each time the display
flashes the letter

and can be washed by hand

or in the

dishwasher at 65°

When washing it in the dishwasher it must be
washed without any dishes using

suitable

under the rangehood. When frying foods,

appliance.