Kleenmaid CCT6010 - Manual (Page 16)

14
INSTALLATION INSTRUCTIONS
The installation must be perfomed by a qualified electrical contractor.
How to stick the gasket:
The gasket supplied with the hob prevents the intrusion of liquids into the cabinet below.
It’s installation has to be done carefully, in conformity with the following drawing.
Fitting - installing:
The cut out sizes are:
•
Ensure that there is a distance of 50 mm between the hob and the wall or sides.
•
The hobs are classified as “Y” class for heat protection. Ideally the hob should be installed with plenty of
space on either side. There may be a wall at the rear and tall units or a wall at one side. On the other side,
however, no unit or divider must stand higher than the hob.
•
The piece of furniture or the support in which the hob is to be fitted, as well as the edges of furniture, the
laminate coatings and the glue used to fix them, must be able to resist temperatures of up to 100 °C.
•
Do not install the hob at the top of a non ventilated oven or a dishwasher.
•
Ensure under the bottom of the hob casing a space of 20 mm, to ensure a good air circulation of the
electronic device.
•
If a drawer is placed under the hob, avoid putting into this drawer flammable objects (for example:
sprays) or non heat-resistant objects.
•
Materials which are often used to make worktops expand on contact with water. To protect the cut out edge,
apply a coat of varnish or special sealant. Particular care must be taken when applying the adhesive joint
supplied with the hob to prevent any leakage into the supporting furniture. This gasket ensures a good seal
when used in conjunction with smooth work top surfaces.
•
The safety gap between the hob and the cooker hood placed above must comply with the recommendations
of the hood manufacturer. In case of no instructions, a distance of 760 mm minimum should apply.
•
The connection cord should not be subjected, to any mechanical constraint.
•
The cooktop underside temperature exceeds 95 c, an underbench board is required to be installed to
prevent the underbench access.
•
WARNING: Use only hob guards designed by the manufacturer of the cooking appliance or indicated by the
manufacturer of the appliance in the instructions for use as suitable or hob guards incorporated in the
appliance. The use of inappropriate guards can cause accidents.
Cut size (mm) Glass size (mm)
Ref. Width Depth Width Depth Thickness
w d W D
CCT6010 560 490 590 520 4
CCT8010 750 490 780 520 4
Stick the gasket (2) two millimeters from the
external edge of the glass, after removing the
protection tape (3).