Kleenmaid SOE100A - Manual (Page 8)

8
I nstalling your oven
The appliance should only be connected by a professional electrician.
To ensure electrical safety, the equipment to be fitted must be inserted
in units fully adapted to this purpose and conforming to standards.
Connecting to the power supply :
- You should use an earthed plug to connect to the power supply. In case of a
direct connection, the main switch terminal should be at least 3 mm apart.
- The electric plug should remain accessible. Do not use an extension lead or
multiple plug.
- We cannot be held responsible for any incident caused by the machine
being badly earthed.
- T he machine must be fitted in compliance with the applicable regulations in your
state as well as any extra instructions from the Electricity Company.
- When carrying out maintenance, be sure to unplug the appliance from the
mains!
- Defective appliances should not be used.
In the event of problems or defects
becoming apparent, turn off the appliance and/or activate the cutout.
- For safety reasons, any repairs to be carried out on appliances, particularly on
parts conducting electricity, must only be carried out by professional electricians
or technicians from the After Sales Service Department trained in this field, in
view of the risks for the user.
In the event of a problem, please contact our After
Sales Service Department directly 1300 652 100.
- The appliance should only be used when it is fully installed. In this way you are
protected against contact with electrical components.
1. Place the appliance in front of the space into which it is to be installed and
plug it into the mains.
2. Insert the steam oven into the space set aside for it.
Ensure that the cable does not become trapped as you insert the appliance.
3. Attach the appliance in various places using a minimum of 2 screws.
Alternatively
If the steam oven is installed along with an oven or a microwave, it should
always be placed in the lowest position.
E
lectrical connections
A
ssembly
Kleenmaid vapeur_GB.qxd 10/07/03 10:28 Page 8