Kleenmaid OCCDB - Manual (Page 10)

A S S E M B L Y 10 10
TEST FOR LEAKS WITH A
SOAP SOLUTION, NEVER WITH AN
OPEN FLAME (Refer to page 4)
CONNECTING TO, AND DISCONNECTING
FROM GAS SOURCE
2. Attach cylinder connection
device of regulator and hose
assembly to cylinder
valve outlet.
Tighten firmly.
3. Open the gas
cylinder valve
fully to allow gas to flow.
4. Leak test all accessible
connections thoroughly
using a soapy water
solution prior to lighting
the barbecue.
Refer to Safety information, page 4.
5. If a leak is found, turn gas cylinder valve off and do not use
barbecue until repairs or replacement can be made.
DISCONNECTING FROM GAS SOURCE
1. Turn the burner control ‘OFF’.
2. Turn the gas cylinder valve off fully.
3. Detach the regulator assembly from gas cylinder valve.
CONNECTING TO GAS SOURCE
1. Place the gas cylinder into the gas cylinder pull-out tray and
face the gas cylinder valve to the right
front corner.
Secure with the
wing bolt.
CAUTION: When the appliance is not in use,
the as must be turned off at the gas cylinder.
This barbecue is also certified for use on natural gas.
Barbecues factory set for use on natural gas are labelled
accordingly.
Contact your place of purchase for advice in relation to using your
barbecue on natural gas.
Refer to back page for contact details.
Barbecues for use on natural gas must be installed by an
authorised person.
NATURAL GAS INSTALLATION
With all burners operating at maximum setting, set the gas pressure
at the test point located at the manifold inlet to 0.95 kPa.
SETTING TEST POINT PRESSURE
IMPORTANT: Before connecting and disconnecting
barbecue to gas source, ensure burner controls are
in ‘OFF’ position.
NOTE: The ‘OFF’ position on the control panel is
identified by either a small black dot / a short vertical
black line / or the word ‘OFF’.
When the marking, or the word ‘OFF’ printed on
the control knob, aligns with the printed marking on
the control panel, then the burner is in the fully off
position.
CAUTION: When the appliance is not in use, the gas
must be turned off at the gas cylinder.
Familiarise yourself with the general information and safety
guidelines located at the front of this booklet. Check to see that
gas cylinder is filled and that end of each burner tube is properly
located over each valve orifice. Set burner controls to
‘OFF’
position.
ENSURING BURNER CONTROLS ARE OFF
• DISCONNECT AND REMOVE GAS
CYLINDER WHEN MANOEUVRING THE
BARBECUE OVER UNEVEN SURFACES
OR CARRYING UP AND DOWN STAIRS.
• IF THIS INFORMATION IS NOT
FOLLOWED EXACTLY, A FIRE
CAUSING DEATH OR SERIOUS INJURY
MAY OCCUR!
• DO NOT STORE A SPARE GAS
CYLINDER UNDER OR NEAR THIS
APPLIANCE.
• THIS BARBECUE IS ONLY TO BE
USED OUTDOORS.
Direction for
tightening
Gas
cylinder
Gas cylinder
pull-out tray
Cylinder valve
outlet