Kleenmaid CH600SW - Manual (Page 3)

The present hob has 4 tensioning brackets with fastening claws. For their positions see figure
below.
Warning:
For safety purposes, the delivered tensioning brackets must be
used. The contact protection is guaranteed only after installation!
Do not use the hob before it has been built-in. The surfaces of
heating and cooking appliances become hot when in use.
Therefore keep children away. Be careful when preparing food in
hot fat or oil because overheated fat or oil could catch fire easily!
Do not leave the appliance unattended when preparing food
with fat or oil (e.g. chips)!
The mains cables of other appliances (e.g. hand mixers) must not
get into contact with the hot hob surface.
The following cable types can be used for connecting to the mains:
The line marked green and yellow (PE) is to be connected to the terminal showing the pro-
tective conductor symbol
!
Connect the mains cable in the appliance as follows:
Depending on the power and type of connection, the
appliance has to be fuse - protected by the installation of
the house as follows:
The electric installation of the house must provide an all-
pole isolator with a minimum contact gap of 3 mm (e.g.
line safety switch, circuit-breaker, contactor).
If the appliance is provided with a superposed residual-cur-
rent-operated breaker, this breaker has to be sensitive to
pulsed currents.
The protection against accidental contact is only effective after the appliance has been com-
pletely built-in.
DB00641-00-
1
X
X X
X
CONNECTION TO MAINS
3
Figure 3
DB00648-00-1
220 V-240 V
L N
~
connection type power as per nameplate fuse
220-240 V
~
5,0 kW 1 x 16 A
220-240 V
~
5,5 ............7,0 kW 1 x 25 A
Figure 4
connection type cable type
400 V 2 N
~
H 05 RR F4G 1,5 (4 x 1,5 mm2) or
(two-phase) H 05 VV F4G 1,5 (4 x 1,5 mm2)
220-240 V
~
H 05 RR F3G 2,5 (3 x 2,5 mm2) or
(single-phase) H 05 VV F3G 2,5 (3 x 2,5 mm2)