Kleenmaid CH605SX - Manual (Page 7)

Instructions for Use, Building- in and Connecting 7
Installation instructions
Caution !
•
Cabinetry into which the cooktop is installed
must be treated with temperature resistant
adhesives (100°C), otherwise they may
discolour or distort because of inadequate
temperature resistance.
•
The cooking hob is intended for building into a
worktop of 60cm width or more above the
kitchen cabinetry.
•
Kitchen cabinets must not be equipped with a
drawer. If the kitchen has a built-in horizontal
shelf, it must be at a distance of not less than
15 cm from the bottom surface of the worktop.
The space between the shelf and the cooktop
must be empty and may not be used for
storage of utensils.
•
The use of hard wood decorative borders
around the worktop behind the appliance is
allowed. In such case the minimum distance
remains as indicated on the installation
illustrations.
•
Minimum distance between the built-in cooktop
and rear wall is indicated in the illustration for
the installation of the built-in cooktop.
•
The appliance may be installed in any worktop
with a thickness from 30 mm to 50 mm.
Dimensions of the built-in hob opening
Installation procedure
•
Worktop must be placed absolutely horizontal.
•
Suitably protect the edges of the cutout.
•
Fasten the 4 supplied tightening brackets with
the 4 supplied screws to the front and the rear
side of the cooking hob and to the prepared
cutout.
•
Connect the cooking hob to the mains power
supply and to the gas supply (see instructions
for the connection of the cooking hob to mains
power supply and gas supply)
•
Stick the supplied self-adhesive seal to the
bottom edges of the cooking hob.
•
Insert the hob into the cutout.
•
Press the hob firmly towards the worktop from
above.