2 machine introduction, 3 positioning and location of the machine – Kemppi KMS 400 AS User Manual

Page 7

2.2 Machine introduction

H12

H11
S11

X11

X12

X14

6,3A

X13

X15

F11

F11

Fuse for connection for control table

6.3 A delayed

X12

Earth connection

H11

Signal lamp

I/O

X14 , X15

Connection for control cable parallel

H12

Warning lamp for thermal protection

Inlet of mains cable

S11

Main switch

I/O

X11, X13

Welding connection

parallel

2.3 Positioning and location of the machine

Place the machine on a firm, dry and level surface. Where possible, do not allow dust or other

impurities to enter the machines cooling air flow. Preferably site the machine above floor level;

for example on a suitable carriage unit.
Notes for positioning the machine

• The surface inclination should not exceed 15 degrees.

• Ensure the free circulation of the cooling air. There must be at least 20 cm of free space in

front of and behind the machine for cooling air to circulate.

• Protect the machine against heavy rain and direct sunshine.

NOTE!

The machine should not be operated in the rain as the protection class of the machine,

IP23S, allows for outside preserving and storage only.

NOTE!

Never aim metallic grinding spray/sparks towards the equipment.