Kemppi SF 52W - Manual (Page 11)

9
© Kemppi Oy / 1515
EN
Memory functions (15)
WIRE INCH GAS TEST
SET
ON
CH
PANEL
SAVE
SET
ch clear ch remote
MEMORY
SELECT
quick
setup
weld
data
ARC FORCE
DYNAMICS
4T
2T
SETUP
MMA PEN
MMA
WISE
1-MIG
MIG
POWER
U
SYNERGIC
PROGRAM
A V
m/min
mm
SF 53W
W004270
/ MINILOG
Storage of settings
The memory functions can be used to record useful welding values in the memory. There are
ten different memory locations: 0 … 9.
In addition to welding values (wire feed speed, welding voltage), function options such as
2T/4T, Creep Start, and Crater Level are recorded in the memory.
Storage in memory is performed as follows:
1. Press the MEMORY button twice; the SET light begins to flash if the channel is not in use.
If the channel is in use, the light remains lit. If the memory is empty, press the MEMORY
key once to get in SET mode.
2. Select the desired memory channel with the CH key.
3. Make the settings and store them in the memory by pressing the SAVE button.
4. Press the MEMORY key twice. Notice that the ON light is lit.
5. Begin welding.
If you wish to change some values, the light must be switched from the ON setting to the SET
setting to enable you to select the required parameters. Press the SAVE button to complete
the procedure. It is also possible to save the parameters of the current weld by pressing SET
when the memory function is in OFF status (all lights off). The channel can be cleared by
pressing MEMORY and the CH button simultaneously in SET mode.
Use of stored settings
1. Press the MEMORY button.
2. Select the memory channel via the CH button.
3. Begin welding.
Remote Selection Button (17)
WIRE INCH GAS TEST
SET
ON
CH
PANEL
SAVE
SET
ch clear ch remote
MEMORY
SELECT
quick
setup
weld
data
ARC FORCE
DYNAMICS
4T
2T
SETUP
MMA PEN
MMA
WISE
1-MIG
MIG
POWER
U
SYNERGIC
PROGRAM
A V
m/min
mm
SF 53W
W004270
/ MINILOG
Short Press: Panel /Gun Remote / Hand remote selection. If remote auto recognition is
selected ON, only those remote controls which can be found are selected.
Long Press: CH remote function ON/OFF. Gun remote or Hand remote control must be first
selected before CH remote function can be selected ON/OFF. When active, memory channels
are selectable from the remote control device.
The Ch remote function enables selection of memory channels via the selection controller
located on the gun. The function is activated by pressing REMOTE and CH buttons
simultaneously. When the CH-remote is activated the light in remote control or in gun control
starts to flash.