Delta D29382 - Manual (Page 12)

12- ENG D29382
6. Connect the high pressure hose (i) to the water outlet on the unit. The water
outlet is marked OUT.
7. Assemble quick-connect adapter (k) to water inlet.
8. Connect the quick-connect (j) to the water supply hose.
9. Connect quick-connect (j) to quick connect adapter (k) at the water inlet.
NOTE: The water supply must provide a minimum of 5 gallons per minute.
10. Make sure high pressure hose and water supply hose are securely
connected.
11. Connect the desired nozzle to spray
wand. To connect rotary (a) and variable
spray nozzle (b), turn clockwise until it
snaps into place. To remove nozzle, turn
nozzle counter clockwise to remove. To
connect chemical application unit (c) see
How To Use Cleaning Solution
Application Unit in this section.
12. Turn water supply on.
j
k
j
a
b
c
STARTING YOUR PRESSURE WASHER
NOTE: Make sure water supply is turned on.
1. Disengage the safety catch as shown.
Depress trigger to allow air to escape and
to discharge residual pressure in the pipes.
2. With the trigger depressed, place the ON-
OFF switch in the On position. When
starting motor, always keep the trigger
depressed.
If after running unit for a few minutes it does not maintain
steady water pressure, turn unit off to prevent damage to the
unit and see the troubleshooting guide for instructions.
i
k