Dixon 2301 - Manual (Page 11)

SPECIFICATIONS
The monocoque design chassis of the Model ZTR 2301 incorporates CMC laser
and CNC brake processes to form the twin 12 gauge side frames and 7 gauge
transmission and engine base plate.
All body parts are made of rotational molded polyethylene. Front body contains
access panel for battery service. Seat tilts forward to allow/transmission service.
11 GA stamped steel construction.
Single 30" cut blade.
Cut height approximately 1" to 4" via 7 position lift handle.
Mechanical; hand lever engagement.
Each rear wheel is independently driven by chain and sprockets through a friction
mechanical drive.
14HP Kohler Command, 4-Cycle, Single Cylinder, Overhead Valve, Air-Cooled,
Pressure Lubricated, With Oil Filter, Vertical Shaft, Aluminum Head and Block
with Cast Iron Cylinder Liner.
Electric by key switch operation with safety interlocks on parking brake and blade
drive.
Front 410 X 3.50X4 ribbed tread. °
Rear 16 X 6.50 X 8 Multi Trac Tread.
Fuel - 2.0 gallons total. . , ' ' •
Engine: 1.25 quarts oil.
Width 36" outside rear wheel measurement. :
Height 35"" to top edge of seat.
Length 66.5" hitch tab to front bumper.
Weight 475 Ibs.
Additional information provided in service instructions underthe individual
component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
Model ZTR 2301
CHASSIS:
BODY: MOWER
DECK:
BLADE DRIVE:
TRANSMISSION:
ENGINE:
STARTING SYSTEM:
TIRES:
CAPACITIES:
DIMENSIONS:
NOTE:
Page 8