Danby PREMIERE DDR7009REE - Manual (Page 8)

1) Power Key: On / Off
2) Fan Speed Key: High/Low
3) On / Off Timer Key:
In running mode: Auto switch Off
In standby mode: Auto switch on
4) Temperature display selector button (Celsius / Fahrenheit): Press the
°C/°F switch button to toggle between °C and °F.
5) Timer / Temperature Buttons:
A) Used for adjusting the timer and thermostat.
B) The default display is room temperature.
C) When “+” or “-” button is pressed, the set temperature is displayed and
may be adjusted. After 10 seconds the display will revert back to room
temperature.
The remote operates within a range of 6 meters (16.4 ft.) from the receiver
located inside the main unit. Any obstruction between the receiver and
remote may cause signal interference, limiting the ability to program the
main unit.
This Class B digital apparatus complies with Canadian ICES-003.
The functions work the same as your dehumidifier’s touch controls.
Batteries: Remove the cover on the back of the remote controller and insert the batteries with the (+) and (-)
poles pointing in the proper direction.
CAUTION: Use only AAA or IEC R03 1.5V batteries.Remove the batteries if the remote controller is
not used for one month or longer. Do not attempt to recharge the supplied batteries. All batteries should be
replaced at the same time. Do not dispose of the batteries in a fire as they may explode.
OPERATING INSTRUCTIONS
REMOTE
CONTROL
PLACING BATTERIES
IN REMOTE CONTROL
1
2
3
4
5
7