JLCooper MCS3-SP-RS422 - Manual (Page 6)

6
Connecting the MCS3-SP to a Deck
Connect the supplied external power supply to the power jack on
the MCS3-SP captive cable. In case a replacement supply ever is
used, the power supply should be rated at 9 to 12 volts DC, 500
mA, with a center positive 2.1 mm plug. The JLCooper part
number is 651026.
Next, connect MCS3-SP 9 Pin cable to the 9 Pin remote input of
the machine that you are controlling. In some cases, you may need
use the supplied gender changer to connect the MCS3-SP to
existing wiring.
Connecting the MCS3-SP to a Computer
Connect the supplied external power supply to the power jack on
the MCS3-SP captive cable. In case a replacement supply ever is
used, the power supply should be rated at 9 to 12 volts DC, 500
mA, with a center positive 2.1 mm plug. The JLCooper part
number is 651026.
Next, connect MCS3-SP 9 Pin cable to the 9 Pin remote input of
the computer system that you are controlling. In some cases, the
computer may have an RS-422 card installed (this is NOT the
standard serial or com port found on most computers) or you may
need to use an external RS-232 to RS-422 converter (such as the
Rosetta Stone Interface Adapter from Addenda). You may need to
use the supplied gender changer.