Jetway Computer NC63 - Manual (Page 40)

The setting ranges from 1.818v(Default) to 2.500v.
3-13 Password Setting
You can set either supervisor or user password, or both of them. The differences are:
Change Supervisor password: Can enter and change the options of the setup menus.
Change User password: Can only enter but do not have the right to change the options of the
setup menus. When you select this function, the following message will appear at the center
of the screen to assist you in creating a password.
Enter New Word:
Type the password, up to eight characters in length, and press . The password typed
now will clear any previously entered password from CMOS memory. You will be asked to
confirm the password. Type the password again and press . You may also press
to abort the selection and not enter a password.
To disable a password, just press when you are prompted to enter the password. A
message will confirm that the password will be disabled. Once the password is disabled, the
system will boot and you can enter Setup freely.
PASSWORD DISABLED.
When a password has been enabled, you will be prompted to enter it every time you try to
enter Setup. This prevents an unauthorized person from changing any part of your system
configuration.
3-14 Load Optimal Defaults/ Load Standard Defaults
Load Optimal Defaults
When you press on this item, you get a confirmation dialog box with a message
similar to:
Pressing loads the default values that are factory settings for optimal performance
system operations.
34