Jetway Computer NC84E - Manual (Page 35)

30
Clear NVRAM
Use the item to clear NVRAM during System Boot. The optional settings are: No; Yes.
Plug &Play O/S
The optional settings are: No; Yes
No: Let the BIOS configure all the devices in the system.
Yes: Let the operating system configure Plug and Play devices, not required for boot if
your system has a Plug and Play system.
PCI Latency Timer
Value in units of PCI clocks for PCI device latency timer register.
Allocate IRQ for PCI VGA
The optional settings are: No; Yes.
Yes: Assigns IRQ to PCI VGA card if card requests IRQ.
No: Does not assign IRQ to PCI VGA card even card requests an IRQ.
Palette Snooping
The optional settings are: Enabled; Disabled.
Enable: inform the PCI device that an ISA graphics devices is installed in the system
so the card will function correctly.
PCI IDE Bus Master
The optional settings are: Enabled; Disabled.
Enable: BIOS uses PCI busmastering for reading/writing IDE devices.
Offboard PCI/ISA IDE Card
Some PCI IDE cards may require this to be set to the PCI slot number that is holding
the card.
IRQ Resources
Press Enter to set values for sub-items as: IRQ5; IRQ7; IRQ9; IRQ10; IRQ11; IRQ14;
IRQ15.