Jetway Computer NC9E - Manual (Page 40)

35
The optional settings are：[Disabled], [2F8/IRQ3], [3E8/IRQ4],[2E8/IRQ3].
Serial Port 2 RS485 Select
The optional settings
are：[Disabled(RS232)]; [Enabled(RS485)].
Parallel Port Address
Use this item to allow BIOS to select parallel port base addresses.
The optional settings are: [Disabled]; [378]; [278]; [3BC].
Parallel Port Mode
The optional settings are: [Normal]; [Bi-Directional]; [ECP]; [EPP]; [ECP & EPP].
Watchdog Timer Select
This item is used to activate the watchdog function. The optional settings are: [Enabled];
[Disabled].
When set as [Enabled], The following sub-items shall appear:
WatchDog Timer Val
User can type a number in the range of 4 to 255.
WatchDog Timer Unit
The optional settings are: [Sec.]; [Min.].
Serial Port 2 Mode
The optional settings are: Normal, IrDA(1.6us), IrDA(3/16 bit)
3-8 Power Management Setup
The Power Management Setup allows you to configure your system to most
effectively save energy saving while operating in a manner consistent with your own
style of computer use.