Jetway Computer NC9VL - Manual (Page 37)

32
always be enabled.
USB0/USB1 Wake-up from S3-S4
*This item will only show when ‘ERP Support’ is set as [Disabled].
The optional settings are: [Disabled]; [Enabled].
USB wake up is affected by ERP function in S4. Please disable ERP before
activating this function in S4.
USB2/USB3 Wake-up from S3-S4
*This item will only show when ‘ERP Support’ is set as [Disabled].
The optional settings are: [Disabled]; [Enabled].
USB wake up is affected by ERP function in S4. Please disable ERP before
activating this function in S4.
System State after Power Loss
Use this item to select AC power state when power is re-applied after a power
failure. The optional settings are: [Always Off]; [Always On]; [Former State].
 System Agent (SA) Configuration
 Graphics Configuration
Press [Enter] to further setting graphics configuration.
Aperture Size
The optional settings are: [128MB]; [256MB]; [512MB].
DVMT Pre-Allocated
Use this item to select DVMT 5.0 pre-allocated (fixed) graphics memory size used
by the internal graphics device.
The optional settings are: [32M]; [64M]; [96M]; [128M]; [160M]; [192M]; [224M];
[256M]; [288M]; [320M]; [352M]; [384M]; [416M]; [448M]; [480M]; [512M]; [1024M].
DVMT Total Gfx Mem
Use this item to select DVMT 5.0 total graphics memory size used by the internal
graphics device.
The optional settings are: [128MB]; [256MB]; [MAX].
Primary IGFX Boot Display
Use this item to select the video device which will be activated during POST. This
has no effect if external graphics present. 'Secondary boot display selection will
appear based on your selection. VGA modes will be supported only on primary