Jetway Computer NC9VL User Manual
Page 33
28
Use this item to set CPUFAN/SYSFAN full speed temperature. Fan will run at full
speed when above this temperature.
CPUFAN / SYSFAN Full-Speed Duty
Use this item to set CPUFAN/ SYSFAN full speed duty. Fan will run at full speed
when above the pre-set duty.
CPUFAN / SYSFANIdle-Speed Temperature
Use this item to set CPUFAN/ SYSFAN idle speed temperature. Fan will run at idle
speed when below this temperature.
CPUFAN / SYSFAN Idle-Speed Duty
Use this item to set CPUFAN/ SYSFAN idle speed duty. Fan will run at idle speed
when below the pre-set duty.
Shutdown Temperature Configuration
Use this item to select system shutdown temperature.
The optional settings are: [Disabled]; [70
o
C/156
o
F]; [75
o
C/164
o
F]; [80
o
C/172
o
F];
[85
o
C/180
o
F]; [90
o
C/188
o
F].
CPUFAN Type
The default setting value is [4-Pin].
SYSFAN Type
The optional settings are: [3-Pin]; [4-Pin].
Network Stack
Press [Enter] to go to ‘Network Stack’ to enable or disable UEFI network stack.
Network Stack
The optional settings are: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
Ipv4 PXE Support
The optional settings are: [Disabled]; [Enabled].
Use this item to enable Ipv4 PXE Boot Support. When set as [Disabled], Ipv4 boot
optional will not be created.
Ipv6 PXE Support
The optional settings are: [Disabled]; [Enabled].
Use this item to enable Ipv6 PXE Boot Support. When set as [Disabled], Ipv4 boot
optional will not be created.