Jetway Computer NF9KC - Manual (Page 36)

31
► PCH-FW Configuration
Press [Enter] to view ME information and configure Management Engine
technology parameters.
► Firmware Update Configuration
Press [Enter] to make settings for ‘ME FW Image RE-Flash’. User can use this
item to enable or disable ME FW Image Re-Flash function.
► USB Configuration
Legacy USB Support
The optional settings are: [Auto]; [Disabled]; [Enabled].
EHCI Hand-off
The optional settings are: [Disabled]; [Enabled].
USB Mass Storage Driver Support
Use this item to enable or disable USB mass storage driver support.
USB Transfer time-out
Use this item to set the time-out value for control, bulk, and interrupt transfers.
The optional settings: [1 sec]; [5sec]; [10sec]; [20sec].
Device reset time-out
Use this item to set USB mass storage device start unit command time-out.
The optional settings: [10sec]; [20sec]; [30sec]; [40sec].
Device power-up delay
Use this item to set maximum time the device will take before it properly reports
itself to the host controller. ‘Auto’ uses default value: for a root port it is 100 ms, for
a hub port the delay is taken from hub descriptor. The optional settings: [Auto];
[Manual].Select [Manual] you can set value for the following sub-item: Device