Jetway Computer NF9Q - Manual (Page 42)

37
One EHCI controller must always be enabled.
*When set as [Manual], the following sub-items shall appear:
Route USB 2.0 pins to which HC?
The optional settings are: [Route Per-Pin]; [Route all Pins to EHCI]; [Route all Pins
to XHCI].
Enable USB 3.0 pins
The optional settings are: [Select Per-Pin]; [Disable all Pins]; [Enable all Pins].
Azalia
Use this function to control the detection of the Azalia device.
The optional settings are: [Disabled]; [Enabled]; [Auto].
Onboard LAN1 Controller
Use this item to enable or disable onboard LAN1 controller.
Onboard LAN2 Controller
Use this item to enable or disable onboard LAN2 controller.
Wake on LAN2
Use this item to enable or disable integrated LAN to wake the system. The
Wake on LAN can not be disabled if ME is on at Sx state.
SLP_S4 Assertion Width
Use this item to select a minimum assertion width of the SLP_S4# signal to ensure
that the DRAMs has been safely power-cycled.
The optional settings are: [1-2 Seconds]; [2-3 Seconds]; [3-4 Seconds]; [4-5
Seconds].
Restore AC Power Loss
Use this item to select AC power state when power is re-applied after a power
failure. The optional settings are: [Power Off]; [Power On]; [Last State].
 System Agent (SA) Configuration
Press [Enter] to make settings for the following sub-items:
VT-D
The optional settings are: [Enabled]; [Disabled].
*This item might not be available depending on configuration.
Azalia Internal HDMI Codec
Use this item to enable or disable DP/HDMI/DVI port audio device.
The optional settings are: [Enabled]; [Disabled].