Jetway Computer NF9Q - Manual (Page 40)

35
CPUFAN / SYSFAN1/ FAN2 Full-Speed Duty
Use this item to set CPUFAN/SYSFAN1/SYSFAN2 full speed duty. Fan will run at
full speed when above the pre-set duty.
CPUFAN / SYSFAN1/ FAN2 Idle-Speed Temperature
Use this item to set CPUFAN/SYSFAN1/SYSFAN2 idle speed temperature. Fan
will run at idle speed when below this temperature.
CPUFAN / SYSFAN1/ FAN2 Idle-Speed Duty
Use this item to set CPUFAN/SYSFAN1/SYSFAN2 idle speed duty.. Fan will run at
idle speed when below the pre-set duty.
 Network Stack
Press [Enter] to go to ‘Network Stack’ to enable or disable UEFI network stack.
Network Stack
The optional settings are: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
Ipv4 PXE Support
The optional settings are: [Disabled]; [Enabled].
Use this item to enable Ipv4 PXE Boot Support. When set as [Disabled], Ipv4 boot
optional will not be created.
Ipv6 PXE Support
The optional settings are: [Disabled]; [Enabled].
Use this item to enable Ipv6 PXE Boot Support. When set as [Disabled], Ipv4 boot
optional will not be created.