Jetway Computer NC9S - Manual (Page 38)

33
WatchDog Timer
Use this item to enable or disable WatchDog Timer Control. When set as
[Enabled], the following sub-items shall appear:
WatchDog Timer Value
User can set a value in the range of 4 to 255.
WatchDog Timer Unit
The optional settings are: [Sec.]; [Min.].
ATX Power Emulate AT Power
This item support Emulate AT power function, MB power On/Off control by power
supply. Use needs to select ‘AT or ATX Mode’ on MB jumper at first (ATX Mode &
AT Mode Select).
The optional settings are: [Enabled]; [Disabled].
Case Open Detect
The optional settings are: [Enabled]; [Disabled].
This item to controls detect case open function.
► PC Health Status
Press [Enter] to view hardware health status and set ‘Shutdown Temperature’.
Shutdown Temperature
Use this item to select system shutdown temperature.
The optional settings are: [Disabled]; [70 o C/156 o F]; [75 o C/164 o F]; [80 o C/172 o F];
[85 o C/180 o F]; [90 o C/188 o F].
► SmartFan Configuration
Press [Enter] to make settings for SmartFan Configuration:
SYSFAN1 Type/ SYSFAN2 Type
The optional settings are: [3 pin]/ [4 pin].
CPUFAN /SYSFAN1/ SYSFAN2 Smart Mode
The optional settings are: [Enabled]; [Disabled].
When set as [Enabled], the following sub-items shall appear:
CPUFAN / SYSFAN1/ SYSFAN2 Full-Speed Temperature
Use this item to set CPUFAN/FAN1/FAN2 full speed temperature. Fan will run at
full speed when above this temperature.