Dacor WINESTEWARD EF24LWCZ1SS - Manual (Page 7)

5
Operating Your Appliance
Turning on the Fan
When storing wine for long periods of time, turn on the fan. The
fan will increase the humidity level, which prevents bottle corks
from drying out. The fan will run continuously until turned off.
To turn on the fan, push the • LIGhT and ALARM buttons at the
same time.
When the fan is on, pushing • the LIGhT and ALARM buttons at
the same time turns it off.
Alarm
The alarm helps to protect your wines against
excessive temperature fluctuations. The alarm
sounds when the door is open for longer than
about 60 seconds. It also sounds when the interior
gets too warm or too cold. The temperature
display will also flash. It will continue to flash until
the temperature problem has been fixed, even if
the alarm has been muted.
To mute the alarm, push the • ALARM button.
Interior Lighting
You can set the interior lighting so that it is on all
the time, or so that it comes on only when the
door is open.
To make the light stay on (or turn off)
when the door is closed:
P • ush the light button.
Setting up the Display (Set-up Mode)
In set-up mode you can turn the child resistant lock on and off
(see page 6 for details), set the temperature scale to Fahrenheit
or Celsius, and adjust the brightness of the display.
Changing the temperature scale (ºF or ºC)
You can select the temperature scale that the unit uses to display
the temperature settings:
P • ush and hold the LIGhT button for about five seconds to enter
set-up mode. The display will begin to flash.
Push the
• UP or DOWN button repeatedly until the degree
symbol “ º ” flashes on the display.
Push the • LIGhT button. “ ºF ” or “ ºC ” will flash on the display.
Push the • UP or DOWN button until the desired temperature
scale flashes on the display. Push the LIGhT button to select
the desired temperature scale.
Push the
• ON/OFF button to exit set-up mode.
Within about two minutes, the appliance will change the
temperature scale on the display.
Changing the Display Brightness
Push and hold the • LIGhT button for about five seconds to enter
set-up mode. The display will begin to flash.
Push the
• UP or DOWN button repeatedly until an “h” flashes on
the display. Push the LIGhT button. The current display
brightness level, from 1 to 5 will flash on the display. h1 is the
lowest level. h5 is the highest level.
Push the • UP or DOWN button repeatedly until the desired
brightness level flashes on the display. Push the LIGhT button
to select the desired brightness level.
Push the
• ON/OFF button to exit set-up mode.