Delta 16" BENCH GRINDERS 23-640 - Manual (Page 7)

7
Fig. 7
2. Insert the short end of mounting rod (F) Fig. 7, into
hole of frame (B) and fasten in place with 1/4-20x3/4"
carriage head screw (G), 5/16” lock washer (H), and 1/4-
20 hex nut (I).
Fig. 8
3. Assemble long end of eye shield mounting rod (F)
Fig. 8, to the side of each wheel guard using bracket (J),
3/8" lockwasher and locking knob (L). The eye shield (A)
is fully adjustable so it can be put in any position by
moving the shield (A) or loosening locking knob (L) and
repositioning rod (F).
FASTENING GRINDER TO
SUPPORTING SURFACE
Fig. 9
IF DURING OPERATION THERE IS ANY TENDENCY
FOR THE GRINDER TO TIP OVER, SLIDE OR
“WALK,” THE GRINDER MUST BE SECURED TO THE
SUPPORTING SURFACE THROUGH THE TWO
HOLES (A) Fig. 9, IN THE GRINDER BASE.
A
F
L
J
A
A
F
B
G H
I
CONNECTING TOOL TO POWER SOURCE
POWER CONNECTIONS
A separate electrical circuit should be used for your tools. This circuit should not be less than #12 wire and should
be protected with a 20 Amp time lag fuse. If an extension cord is used, use only 3-wire extension cords which have
3-prong grounding type plugs and 3-pole receptacles which accept the tool’s plug. Before connecting the motor to
the power line, make sure the switch is in the “OFF” position and be sure that the electric current is of the same
characteristics as indicated on the tool. All line connections should make good contact. Running on low voltage will
damage the motor.
MOTOR SPECIFICATIONS
Your tool is wired for 120 volt, 60 HZ alternating current. Before connecting the tool to the power source, make sure
the switch is in the “OFF” position. The motor provides a no-load speed of 3450 RPM.
GROUNDING INSTRUCTIONS
WARNING: THIS TOOL MUST BE GROUNDED WHILE IN USE TO PROTECT THE OPERATOR FROM
ELECTRIC SHOCK.