Doro PHONE 314C - Manual (Page 9)

English
Making a call
Regular dialling
1. Pick up the handset.
2. Enter the desired number.
Dialling using correcting function
1. Enter the required number. Mistakes can be erased using C.
2. Pick up the handset OR press
Q OR press s , and the number is dialled.
If VOICE is activated the numbers 0-9 will be heard as the numbers are dialled.
Redialling
If the number dialled is engaged or if you wish to redial the last number
dialled, lift the handset (or press s ) and press the redial button r .
Volume control
The handset volume may be adjusted during a call using /
Q
.
To adjust the speaker volume, use (on the side of the phone).
Ring Signal
There is a ring signal strength switch on the side of the telephone:
Ring volume
Mute button
Press and hold z to disable the handset microphone, release z to reconnect
the microphone.
Speaker
1. Press
s . The handsfree function (speaker) will be activated and the
LED indicator next to the button will illuminate.
2. Dial the telephone number. Adjust the speaker volume with the volume
control on the side.
3. Speak towards the microphone located on the front edge of the telephone.
4. Press
s
to terminate the call.
If you wish, you can switch between handset mode and handsfree mode
during the call by pressing s .
Please note!
Please remember that in handsfree speaker mode, it is only possible for one person at a time
to talk. The switch-over between speaker and microphone is automatic and dependent on the
sound level of the incoming call and the microphone respectively. It is therefore essential that
there are no loud noises, e.g. music, in the immediate vicinity of the telephone, as this will
disrupt the handsfree function.