Doro PHONE 314C - Manual (Page 14)

English
Alarm number memory
This telephone has 3 alarm number memories.
Once a number has been stored in a memory location, you only need to press
one button to make the call. The alarm buttons are numbered , M1-M2.
All 3 alarm buttons should have a number stored.
Storing alarm numbers
1. Press
w .
2. Scroll to STORE NUMBER with
v / V . Press OK.
3. Enter the phone number to be stored (up to 22 digits). Press OK.
4. Select speed dial ( , M1-M2) by pressing the corresponding button.
If no number has been stored on the alarm buttons ( , M1-M2) the
phone will beep and flash for 15 seconds, but no number will be dialled.
Even if 3 different alarm numbers are not needed, you should store the same number on
different buttons.
If you need to change a number, store the new number in the same location as the old one.
Making an emergency call with alarm numbers
1. Hold down the desired alarm button , M1-M2 or the cordless alarm button
(approx. 2 seconds) until the phone starts to beep and the light flashes.
2. If you want to terminate the alarm, hold down the desired alarm button ,
M1-M2 or the cordless alarm button (approx. 2 seconds) until the phone stops
to beep and the light stops flashing. It is also possible to interrupt an alarm by
lifting the handset or by pressing the handsfree button.
When an alarm call is activated the phone will start to beep and flash for 15 seconds.
Then the number attached to the activated alarm button ( , M1-M2) will be
dialled.
If the cordless alarm button activates the alarm call the phone will start
dialling .
When the first alarm call is connected, the alarm message will be heard by the
person receiving the call. The recipient should then press zero on his telephone
to accept the call and be connected to the loudspeaker on the caller’s phone. The
call is kept in speaker mode for 3 minutes. If no one replies or the recipient does
not accept the call within 60 seconds, a new alarm call will be initiated to the next
number ( , M1-M2). This procedure is repeated until the call is answered and
accepted, though not more than 20 times per alarm button.
It is also possible to answer incoming calls with the cordless alarm button. When
the phone rings press the button on the cordless alarm button and the call is
answered in speaker mode. End the call by pressing the same button.