Dimplex BF392SD - Manual (Page 2)

SECTION A: FRAMING
Rough-in framing dimensions Firebox dimensions
This fireplace is a zero clearance design. Combustibles may be installed to the edge of the unit. Four nailing
flanges on the sides of the unit are provided to facilitate installation. Insulation and vapor barrier should be placed
a minimum of 2 inches from the unit.
SECTION B: RECOMMENDED POWER SUPPLY WIRE SPECIFICATIONS
For 120 volt installations use two conductor, non-metallic sheath cable with ground wire for the
incoming power supply on fireplace inserts. Use the appropriate wire to meet local and
national electrical codes for rated power consumption.
Use appropriate wire to meet local and national electrical codes for rated power consumption.
RECOMMENDED WIRE AND FUSING REQUIREMENTS
VOLTS WIRE GAUGE FUSE RATING
120 VOLT 14 GAUGE 15 AMP
2