beautypg.com

Saw blades, Recommended accessories – Dremel 1680 User Manual

Page 18

background image

Use only Dremel accessories. Follow instructions that accompany accessories. Use of improper accessories may cause haz-
ards.

LEG SET
Cat. No.
16500 Scroll Saw Stand

Saw Blades

Dremel offers both Plain and Pin-End 5 inch blades.

PIN-END
Pin-End blades permit relatively tight radius cutting in hard and soft wood.

Cat. No.

Suggested Usage

Width Thick TPI

Speed

16412

For cutting wood 3/8” to 2” thick

.110” x .018” x 10

Any

16411

For cutting wood 3/16” to 1” thick

.110” x .018” x 15

Any

16413

For cutting wood thinner than 1/4” thick

.070” x .010” x 18.5

Any

PLAIN-END
The Pin-End blades, while somewhat easier to put in and take out of the machine, do not always produce the same controlled
cutting action provided with the Plain-End blade. These narrow Plain-End blades allow the user to cut more detailed, intricate
patterns and smaller inside cuts.

Cat.No.

Suggested Usage

Width Thick TPI

Speed

16453

For cutting hard and soft woods 1/4” to 2” thick

.062” x .020” x 9.5

High

16446

For close radius cutting in materials 1/8” or thicker

.038” x .016” x 12.5

High

16443

For very tight radius work in thin materials, up to 1/8”

.029” x .012” x 20

High

16440

.022” x .010” x 28

High

16448

.045” x .017” x 11.5

High

SPIRAL
Saws in all directions without turning the workpiece.

Cat. No.

Suggested Usage

Kerf TPI

Speed

16461

For wood, plastic and abrasive materials

.028” - .030” x 46

Any

16463

.034” - .036” x 41

METAL PIERCING
For cutting precious and non-ferrous metals; these must be used at very slow speeds. They perform well on machines
that have variable speed capability and should be lubricated with beeswax, or a light machine oil.
Cat. No.

Suggested Usage

Kerf TPI

Speed

16483

Metals and other hardwood materials.

.033” x .016” x 36

Low

REVERSE TOOTH
Provides a smooth, splinter free finish. Eliminates the need for excessive finish sanding, and leaves a clean sharp edge on
both the top and bottom of your workpiece.

Cat. No.

Suggested Usage

Kerf TPI

Speed

16431

For cutting hard or soft woods up to 1/8” thick.

.029” x .012” x 20

Any

16432

For cutting hard or soft woods 1/8” or thicker

.038” x .016” x 12.5

Any

16433

For cutting hard or soft woods 3/8” to 2” thick

.047” x .017” x 11.5

Any

PERMA-GRIT TUNGSTEN CARBIDE
Shapes and cuts ceramic tiles cleanly and accurately. Cuts intricate patterns easily in any direction. Also use for thin
wood. Not for use on ceramic floor tile.

Cat. No.

Suggested Usage

Kerf Grit

Speed

16471

For very tight radius work in cearmic tile or thin wood.

.031” x .033” 60

Medium

16472

For close radius cutting in ceramic tile or thin wood.

.046” x .048” 120

Medium

18.

Recommended Accessories