Induction Dynamics S1.8ST - Manual (Page 4)

General Information
Please read these instructions thoroughly before attempting to connect and operate the
S1T.
Check Speaker and Parts
Unpack and carefully check each loudspeaker. If you suspect damage from transit, report the
problem immediately to your dealer and/or delivery service. If possible, save the shipping
cartons for future use.
General Care of Your Loudspeaker
Whenever changing speaker wires, interconnect wires, or power cords, always turn off all
equipment. To prevent fire or shock hazard, do not expose the amplifier to rain or excessive
moisture. To avoid electric shock, do not open the amplifier. There are no user serviceable
parts inside.
Your speakers and amplifier come in a high quality finish that is both attractive and durable.
To clean, use a soft, damp cloth. If your drivers become dusty, dust them with a paintbrush
or a brush vacuum attachment. Do not use a strong or abrasive cleaner.
The grille is covered in acoustic cloth. To keep your grille clear of debris, we recommend
you use a lint roller (like you would use on clothes).
Bass and Loudness Contour Controls
Do not use bass or loudness contour controls. Induction Dynamics’ subwoofers produce
very low frequencies without these controls. Use of these controls will make the bass sound
“boomy”, obscure higher frequencies, and possibly cause damage.
S1T Location
S1T speakers are normally freestanding, but may also be built into walls. The S1T was
designed in such a way that the tweeter will be at ear level when the audience is sitting..
The tweeter reproduces high-frequency audio, which our ears perceive as most directional,
so we are most attuned to their level and placement.
A pair of S1Ts should be placed a few feet from the front wall of the listening area, six feet
or more apart. Experiment with the distance between the two speakers to achieve an evenly
spread sound stage. Speakers should be at the same height (with the tweeter at ear level).
To optimize bass response, vary the distance of your S1T speakers from the front wall.
3