ikan IKW1-A - Manual (Page 7)

7
installation problems.
6) DC 12V input. Supports 7~30V when using battery.
FIGURE 2
1) Pairing Button
a. Use this button when pairing multiple receivers to one transmitter or
when using multiple transmitters at the same time.
2) Link LED
a. LED light turns on when connection between transmitter and receiver
is confirmed.
3) Power LED
4) Battery LED
a. LED will blink when battery source is low.
5) Tally LED
a. Indicates Tally Control is in use.
6) SDI/HDMI Switch to choose between SDI or HDMI input
7) Audio In
a. Use this input to receive stereo audio source independent of video
input (e.g. from an external microphone).
8) Remote Port for tethered Tally Controller
9) Infrared Remote Control Sensor