ikan SLD-01 - Manual (Page 6)

Slider
QUICKSTART GUIDE
www.ikancorp.com 713-272-8822
VERTICAL CONFIGURATION
4. Setting up your Slider in a vertical configuration will require the 1.285” 3/8-16 Thumb
Screw. First, stand your Slider up vertically so that the 3/8-16 hole is on top. Next,
allign the center hole on both your Tabletop Feet so that the two sets of feet
intersect with one another. Insert the 3/8-16 Thumb Screw through both sets of
Tabletop Feet and into the Slider Body, and tighten for a secure fit. Finally, stand
your Slider up vertically by flipping it over. Ensure proper balance by using the level
located at the bottom of your Slider and adjusting individual feet.