DeVillbiss Air Power Company D26675 - Manual (Page 11)

11- ENG D26675
HOW TO START
1. Place On/Off switch to “OFF”.
2. Plug the power cord into the grounded outlet.
3. Place On/Off switch to “ON” to start compressor.
4. Check the manufacturer's maximum pressure rating for the air tool,
accessory, or vehicle tire being used. The air compressor outlet pressure
must never exceed the maximum pressure rating.
5. Slowly increase the pressure setting of the adjustable pressure valve. You
should be able to hear and feel air pressure being relieved by the
adjustable pressure valve. If pressure is not being relieved, turn the air
compressor off immediately. The pressure valve must be replaced.
Compressed air from the outfit may contain water
condensation. Do not spray unfiltered air at an item that
could be damaged. Some air operated tools or devices may require
filtered air. Read the instructions for the air tool or device.
SERVICE AND ADJUSTMENTS
Air Hose Replacement
The air hose attached to your compressor has an integral pressure adjusting
valve at the working end of the hose. Should service or replacement be
required, make sure that the pressure adjusting valve is present in the air hose
line.
DO NOT replace the hose with standard hose that is not
equipped with the pressure adjusting valve.
Do not allow hose to become kinked or pinched at any
time. This is important to avoid damage to your
compressor and to maintain pressure adjusting valve control.
STORAGE
1. Set the On/Off switch to "OFF" and unplug the cord.
2. Relieve all pressure from the air compressor head and air hose by turning
the adjustable pressure valve to 10 PSI.
3. Protect the electrical cord and air hose from damage by winding them
loosely around the air compressor.
4. Store the air compressor in a clean and dry location.