Dixon 4500 Series - Manual (Page 17)

17
CONTROLS
BLADE DRIVE:
• Located on the control panel, on
operator’s right.
• To engage the mower blade, pull up on
the switch.
• To disengage mower blade, push down.
CIRCUIT BREAKER :
• Protection of the electrical system is by (1)
15 amp circuit breaker.
• If circuit breaker trips, push button to
reset.
• If this condition repeats, consult dealer for
inspection and repair.
THROTTLE CONTROL LEVER :
• Located on control panel to operator’s right.
• Throttle control for engine speed.
• Choke for engine starting (omit for 4518K).
• Throttle control should be set to
MAXIMUM or wide open setting to insure
adequate cooling of the engine and to
maintain mower deck blade speed while
mowing.
CHOKE CONTROL (4518K only):
• Located on control panel to operator’s right.
• Choke for engine starting.
MOWER DECK CUT HEIGHT LIFT LEVER :
• Located to the left of the operator.
• Controls the cutting height.
• Seven positions of adjustment.
• Move lever in and forward to lower.
• Move lever in and back to raise.
NOTE: Always use high for transport.
4518K
4515B & 4516K