Dixon 4500 Series - Manual (Page 13)

13
SPECIFICATIONS
Model ZTR 4515B, 4516K & 4518K
CHASSIS: Twin 12 gauge side frames, 7 gauge transmission & engine base
plate.
BODY: All body parts made of high density polyethylene. Dent and corrosion
resistant. Front body contains access panel for battery service.
MOWER DECK: 42” Deck: 13 GA Stamped Steel Construction-42” Cut Width
50” Deck: 11 GA Fabricated Construction/Reinforcement Ribs-50”
Cut Width
Cut height approximately 1” to 4” via 7 position lift handle.
BLADE DRIVE: Electric clutch.
TRANSMISSION: Each rear wheel is independently driven by a HydroGear IZT
hydrostatic drive.
ENGINE:
Model 4515B: 15.5 HP Briggs & Stratton Intek ELS (Extended Lift Series), 4-Cycle,
Single Cylinder, Overhead Valve, Air-Cooled, Gasoline, Vertical Shaft
with Cast Iron Cylinder Sleeve, Full pressure lube with spin-on filter
Chrome Valves, Plasma Piston Rings, Pteff Pistons, Platinum Spark
Plugs ,AVS(Anti-vibration System) and extended warranty.
Model 4516K: 16 HP Kohler Command 460 cc, Single Cylinder, Overhead Valve,
Air Cooled, Gasoline, Pressure Lubricated with oil filter, Vertical
Shaft, Aluminum Head and Block with Cast-Iron Cylinder Liner.
Model 4518K: 18 HP Kohler Command Twin Cylinder, Overhead Valve, Air Cooled,
Gasoline, Pressure Lubricated with oil filter, Vertical Shaft,
Aluminum Head and Block with Cast-Iron Cylinder Liner.
STARTING Electric by key switch operation with safety interlock blade drive.
SYSTEM :
TIRES: Front 11 x 4.00 x 5 ribbed tread
Rear 18 x 8.50 x 8 Turf Trac R/S
RECOMMENDED Front 16-21 PSI
TIRE PRESSURE: Rear 8-14 PSI
CAPACITIES: Fuel 2.7 gallons total
Engine B&S - 1.5 quarts oil Kohler - 2 quarts oil with filter
DIMENSIONS: Width 44” maximum track width
Height 42” to top edge of seat
Length 72” hitch tab to front bumper
Weight Power Unit: 463 lbs.
w/42” Deck: 547 lbs.
w/50” Deck: 603 lbs.
Additional information provided in service instructions under the individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE