IBASE MI805 - Manual (Page 11)

INSTALLATIONS
MI805 User’s Manual 7
Installing the Memory
The MI805 board supports two DDR3-1333 memory slots.
Remarks:
J1900 supports two SO-DIMM (w/o ECC) modules. Total maximum
memory supported is 8GB.
Installing and Removing Memory Modules
To install the DDR3 modules, locate the memory slot on the board and
perform the following steps:
1. Hold the DDR3 module so that the key of the DDR3 module aligned
with that on the memory slot.
2. Gently push the DDR3 module in an upright position until the clips of
the slot close to hold the DDR3 module in place when the DDR3
module touches the bottom of the slot.
3. To remove the DDR3 module, press the clips with both hands.
DDR3 Module
Lock Lock
Lock Lock