Control mode, Osd operation – HuddleCamHD RS-232 User Manual
Page 4

Control Mode .
VISCA, PELCO-P and PELCO-D protocol support.
Control interfaces:
o
RJ45 (RS485).
o
Screw Terminal (RS422/RS485).
o
DB9 (RS232).
Baud rate: 1200, 2400, 4800, 9600.
Parameters: 8 bits, 1 stop bit, No parity.
OSD Operation .
Pan & Tilt Control
o
Joystick movement controls the pan and tilt of the camera.
o
Rotation of the joystick controls the zoom of the lens.
Clockwise rotation of the zooms in.
Counter-clockwise rotation zooms out.
o
Control can also be achieved using the following keys:
WIDE, TELE, CLOSE, OPEN, FAR, NEAR.
Zoom, Focus & Iris
o
OPEN: Open Iris (if available on camera).
o
CLOSE: Close Iris (if available on camera).
o
FAR: Far Focus (For manual focus)
.
o
NEAR: Near Focus. (For manual focus).
o
TELE: Tele Zoom.
o
WIDE: Wide Zoom.
Input Number Keys
o
For entering numbers “0” to “9”.
o
Input range 0~65535.
o
Press the “0” continuously to clear the inputs.
Set the Camera ID to be controlled by joystick
o
Number Key + “CAM”.
Set a Preset
o
Number Key + Press and hold “Preset” for 2 seconds.
Select a Preset
o
Number Key + “Preset”.